An automatic glue applicator for putting a consistent amount of glue to the bottom of the bullet. When used with the bullet holder one or two presses on the felt pad and wiping off the bottom is all it takes. Comes with a jar holder with a wipe off pad holder.
Just fill the jar with a half inch of tight bond 2 wood glue and add 20 to 25 drops of water. Install the plunger, felt pad push down on the top to saturate the felt. Push the bullet into the felt pad with the bullet holder. The glue will be applied, the pad will be resaturated and any excess will be sucked back or flow back into the jar.
When done using, push the plunger to the bottom and screw on the lid. Put the jar and holder in a zip lock bag and store upright until the the next time it's used.
3D printed
Works on all conical bullet sizes
This will be included in all the former kits after September of 2023
Video of how to fill and used